Delta Electronics AC Motor Drive VFD-E User Manual page 192

Settings Function
Desired Frequency
9
Attained
Terminal Count Value
10
Attained
Preliminary Count Value
11
Attained
Over Voltage Stall
12
supervision
Over Current Stall
13
supervision
Heat Sink Overheat
14
Warning
15 Over Voltage supervision
16 PID supervision
17 Forward command
18 Reverse command
Zero Speed Output
19
Signal
Communication Warning
20 (FbE,Cexx, AoL2, AUE,
SAvE)
Brake Control (Desired
21
Frequency Attained)
11.06 Multi-function Input Terminal (MI7)
11.07 Multi-function Input Terminal (MI8)
11.08 Multi-function Input Terminal (MI9)
11.09 Multi-function Input Terminal (MI10)
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Active when the desired frequency (Pr.03.02) is attained.
Active when the counter reaches Terminal Count Value.
Active when the counter reaches Preliminary Count Value.
Active when the Over Voltage Stall function operating
Active when the Over Current Stall function operating
When heatsink overheats, it will signal to prevent OH turn
off the drive. When it is higher than 85oC (185oF), it will be
ON.
Active when the DC-BUS voltage exceeds level
Active when the PID function is operating
Active when the direction command is FWD
Active when the direction command is REV
Active unless there is an output frequency present at
terminals U/T1, V/T2, and W/T3.
Active when there is a Communication Warning
Active when output frequency ≥Pr.03.14. Deactivated when
output frequency ≤Pr.03.15 after STOP command.
Chapter 4 Parameters|
Description
4-139