Jog Frequency; Auto-Acceleration / Deceleration - Delta Electronics AC Motor Drive VFD-E User Manual

Chapter 4 Parameters|
01.15

Jog Frequency

Settings
Only external terminal JOG (MI3 to MI12) can be used. When the Jog command is "ON", the
AC motor drive will accelerate from Minimum Output Frequency (Pr.01.05) to Jog Frequency
(Pr.01.15). When the Jog command is "OFF", the AC motor drive will decelerate from Jog
Frequency to zero. The used Accel/Decel time is set by the Jog Accel/Decel time (Pr.01.13,
Pr.01.14).
Before using the JOG command, the drive must be stopped first. And during Jog operation,
other operation commands are not accepted, except commands via the FORWARD,
REVERSE and STOP keys on the digital keypad.
Frequency
01.15
JOG
Frequency
01.05
Min. output
frequency
0 Hz
01.16

Auto-Acceleration / Deceleration

Settings
With Auto acceleration / deceleration it is possible to reduce vibration and shocks during
starting/stopping the load.
During Auto acceleration the torque is automatically measured and the drive will accelerate to
the set frequency with the fastest acceleration time and the smoothest starting current.
4-46
0.10 to Fmax (Pr.01.00)Hz
JOG Accel. Time
01.13
The definition of JOG Accel./Decel. Time
0 Linear acceleration / deceleration
1 Auto acceleration, linear Deceleration.
2 Linear acceleration, auto Deceleration.
3 Auto acceleration / deceleration (set by load)
4 Auto acceleration / deceleration (set by Accel/Decel Time setting)
JOG Decel. Time
01.14
01.12
01.21
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Unit: 0.01
Factory Setting: 6.00
Time
Factory Setting: 0