Group 2 Operation Method Parameters - Delta Electronics AC Motor Drive VFD-E User Manual

Group 2 Operation Method Parameters

Parameter Explanation
Source of First
02.00 Master Frequency
Command
Source of First
02.01
Operation
Command
02.02 Stop Method
PWM Carrier
02.03 Frequency
Selections
Motor Direction
02.04
Control
02.05 Line Start Lockout
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Settings
0: Digital keypad UP/DOWN keys or Multi-
function Inputs UP/DOWN. Last used
frequency saved.
1: 0 to +10V from AVI
2: 4 to 20mA from ACI or 0 to +10V from
AVI2
3: RS-485 (RJ-45)/USB communication
4: Digital keypad potentiometer
5: CANopen communication
0: Digital keypad
1: External terminals. Keypad STOP/RESET
enabled.
2: External terminals. Keypad STOP/RESET
disabled.
3: RS-485 (RJ-45)/USB communication.
Keypad STOP/RESET enabled.
4: RS-485 (RJ-45)/USB communication.
Keypad STOP/RESET disabled.
5: CANopen communication. Keypad
STOP/RESET disabled.
0: STOP: ramp to stop; E.F.: coast to stop
1: STOP: coast to stop; E.F.: coast to stop
2: STOP: ramp to stop; E.F.: ramp to stop
3: STOP: coast to stop; E.F.: ramp to stop
1 to 15kHz
0: Enable forward/reverse operation
1: Disable reverse operation
2: Disabled forward operation
0: Disable. Operation status is not changed
even if operation command source Pr.02.01
is changed.
1: Enable. Operation status is not changed
even if operation command source Pr.02.01
is changed.
Chapter 4 Parameters|
Factory
Setting
1
1
0
8
0
1
Customer
4-7