D.4 Plc Devices; D.4.1 Summary Of Dvp-Plc Device Number - Delta Electronics AC Motor Drive VFD-E User Manual

D.4 PLC Devices

D.4.1 Summary of DVP-PLC Device Number

Items
Control Method
I/O Processing Method
Execution Speed
Program Language
Program Capacity
Commands
Input/Output Contact
X External Input Relay
Y External Output Relay
For general
M Auxiliary
For special
T Timer 100ms timer
16-bit count up for
general
32-bit
C Counter
count
up/down
high-
speed
counter
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
Stored program, cyclic scan
system
Batch processing (when END
instruction is executed)
Basic commands (minimum
0.24 us)
Instruction, Ladder Logic, SFC
500 STEPS
45 commands
Input (X): 6, output (Y): 2
X0~X17, 16 points,
octal number system
Y0~Y17, 16 points,
octal number system
M0~M159, 160
points
M1000~M1031, 32
points
T0~T15, 16 points
C0~C7, 8 points
1-phase input
1-phase 2
C235, 1 point (need
inputs
to use with PG card)
2-phase 2
inputs
Appendix D How to Use PLC Function|
Specifications
Total is
32
points Correspond to external
Total is
192
points
Total is
16
points
Total is
8 points
Total is
1 point
Remarks
I/O refresh instruction is
available
Application commands
(10 ~ hundreds us)
Including the Step
commands
SRAM + Battery
28 basic commands
17 application
commands
Correspond to external
input point
output point
Contacts can switch to
On/Off in program
When the timer
indicated by TMR
command attains the
setting, the T contact
with the same number
will be On.
When the counter
indicated by CNT
command attains the
setting, the C contact
with the same number
will be On.
D-19