Delta Electronics AC Motor Drive VFD-E User Manual page 110

MI1-DCM (close)
Pr.02.01=0
output frequency
Pr.02.05=0 or 2
Change operation
command source
output frequency
Pr.02.05=1 or 3
When the operation command source isn't from the external terminals, independently from
whether the AC motor drive runs or stops, the AC motor drive will operate according to
Pr.02.05 if the two conditions below are both met.
1. When operation command source is changed to external terminal (Pr.02.01=1 or 2)
2. The status of terminal and AC motor drive is different.
And the operation of the AC motor drive will be:
1. When setting 0 or 1, the status of AC motor drive is not changed by the terminal status.
2. When setting 2 or 3, the status of AC motor drive is changed by the terminal status.
MI1-DCM (close)
power is applied
output frequency
Pr.02.05=0 or 1
output frequency
Pr.02.05=2 or 3
The Line Start Lockout feature does not guarantee that the motor will never start under this
condition. It is possible the motor may be set in motion by a malfunctioning switch.
Revision June 2008, 04EE, SW--PW V1.11/CTL V2.11
ON
RUN RUN
STO P STOP
Pr.02.01=1 or 2
ON
OFF
ON
it will run
it won't run
when power is applied
Chapter 4 Parameters|
OFF
This action will follow MI1/DCM
or MI2/DCM status
(ON is close/OFF is open)
OFF
ON
It needs to received a run command
after previous command is cancelled
4-57