Analog Input Delay Time (Aci); Analog Input Delay Time (Aui); Addition Function Of The Analog Input; Loss Of The Aci Signal - Delta Electronics AC Motor Drive VFD-VE Series User Manual

Chapter 4 Parameters|
03-14

Analog Input Delay Time (ACI)

03-15

Analog Input Delay Time (AUI)

Control
VF VFPG
mode
Settings
These input delays can be used to filter noisy analog signal.
03-16

Addition Function of the Analog Input

Control
VF VFPG
mode
Settings
When Pr.03-16 is set to 0 and the analog input setting is the same, the priority for AVI, ACI
and AUI are AVI>ACI>AUI.
03-17

Loss of the ACI Signal

Control
VF VFPG
mode
Settings
This parameter determines the behavior when ACI is lost.
03-18 Analog Output Selection 1
03-21 Analog Output Selection 2 (need to be used with EMV-APP01)
03-24 Analog Output Selection 3 (need to be used with EMV-APP01)
Control
VF VFPG
mode
4-82
SVC FOCPG TQRPG
0.00 to 2.00 sec
SVC FOCPG TQRPG
0 Disable (AVI, ACI, AUI)
1 Enable
Frequency
Fcommand=[(ay bias)*gain]* Fmax(01-00)
Fcommand: the corresponding
frequency for 10V or 20mA
ay : 10 or 16mA
bias : Pr.03-03,Pr. 03-04, Pr.03-05
gain : Pr.03-09, Pr.03-10, Pr.03-11
SVC FOCPG TQRPG
0 Disable
1 Continue operation at the last frequency
2 Decelerate to stop
3 Stop immediately and display E.F.
SVC FOCPG TQRPG
Voltage
10V or 16mA
Revision August 2008, 03VE, SW V2.04
Unit: 0.01
Unit: 0.01
Factory setting: 0.01
Factory setting: 0
Factory setting: 0
Unit: 1
Unit: 1
Unit: 1
Factory setting: 0