Delta Electronics AC Motor Drive VFD-VE Series User Manual page 115

Chapter 4 Parameters|
Settings Functions
Enable pulse position
37
input command
Disable write EEPROM
38
function
Torque command
39
direction
40 Force stop
41 Serial position clock
4-66
Run/Stop
MI=d1
MI=d2
MI=d3
MI=d4
MI=d36
T he motor position
is from enc oder feedbac k
and written into the
cor responding multi-
position of ON/O FF
status of MI1 to MI4
( P r.04-25)
When this function is enabled, the pulse of PG card will
change from speed command to position command. It is
recommended to set Pr.10-23 to 0.
Example: When it is controlled by pulse (Pr.00-20 is set to 5),
please refer to the following diagram for returning home.
R UN
MI=d35
MO= d5
MI=d37
When this function is enabled, you can't write into EEPROM.
When the torque command source is AVI or ACI, it can
change torque direction by enabling this function.
When this function is enabled, the drive will free run to stop.
The position method of the main shaft:
Descriptions
1010 =10
1011 =11
2
cor responds to
cor responds
Pr.04- 24
to Pr.04-25
1
0
1 1
0
0
1 1
T he motor position
is from enc oder feedbac k
and written into the
cor responding multi-
position of ON/O FF
status of MI1 to MI4
( P r.04-24)
Revision August 2008, 03VE, SW V2.04
2
0
1
0
1
Time