Over-Torque Detection Time (Ot1); Over-Torque Detection Selection (Ot2); Over-Torque Detection Level (Ot2); Over-Torque Detection Time (Ot2) - Delta Electronics AC Motor Drive VFD-VE Series User Manual

Chapter 4 Parameters|
Settings
06-08

Over-torque Detection Time (OT1)

Control
VF VFPG
mode
Settings
06-09

Over-torque Detection Selection (OT2)

Control
VF VFPG
mode
Settings
06-10

Over-torque Detection Level (OT2)

Control
VF VFPG
mode
Settings
06-11

Over-torque Detection Time (OT2)

Control
VF VFPG
mode
Settings
Pr.06-06 and Pr.06-09 determine the operation mode of the drive after the over-torque is
detected via the following method: if the output current exceeds the over-torque detection level
(Pr.06-19) and also exceeds the Pr.06-08 Over-Torque Detection Time, the fault code
"OT1/OT2" is displayed. If a Multi-Functional Output Terminal is to over-torque detection, the
output is on. Please refer to Pr.02-11~02-14 for details.
4-98
10 to 250%
SVC FOCPG TQRPG
0.0 to 60.0 sec
SVC FOCPG TQRPG
0 Over-Torque detection disabled.
1 Over-torque detection during constant speed operation, continue to
operate after detection
2 Over-torque detection during constant speed operation, stop
operation after detection
3 Over-torque detection during operation, continue to operate after
detection
4 Over-torque detection during operation, stop operation after
detection
SVC FOCPG TQRPG
10 to 250%
SVC FOCPG TQRPG
0.0 to 60.0 sec
Factory Setting: 0.1
Factory Setting: 0
Factory Setting: 150
Factory Setting: 0.1
Revision August 2008, 03VE, SW V2.04
Unit: 0.1
Unit: 1
Unit: 0.1