Delta Electronics AC Motor Drive VFD-VE Series User Manual page 35

Chapter 2 Installation and Wiring|
Terminal symbols and functions
Terminal
Symbol
FWD Forward-Stop Command
REV Reverse-Stop Command
+24V DC Voltage Source
MI1 Multi-function Input 1
MI2 Multi-function Input 2
MI3 Multi-function Input 3
MI4 Multi-function Input 4
MI5 Multi-function Input 5
MI6 Multi-function Input 6
Digital Frequency Meter
(Open Collector Output)
DFM-DCM
DFM
internal circuit
DCM Digital Signal Common
Multi-function Relay Output 1
RA
(N.O.) a
Multi-function Relay Output 1
RB
(N.C.) b
RC Multi-function Relay Common
Multi-function Relay Output 2
MRA
(N.O.) a
MRC Multi-function Relay Common
2-12
Terminal Function
Max: 48V
50mA
J5
50%
100%
Factory Settings (SINK)
ON: Connect to DCM
ON: Run in FWD direction
OFF: Stop acc. to Stop Method
ON: Run in REV direction
OFF: Stop acc. to Stop Method
+24VDC, 80mA, used for SOURCE mode.
Refer to Pr.02-01 to Pr.02-06 for programming
the Multi-function Inputs.
ON: the activation current is 6.5mA. OFF:
leakage current tolerance is 10μA.
Pulse voltage output monitor signal,
proportional to output frequency
Duty-cycle:
Ratio:
Min. load:
Max. current:
Max. voltage:
Jumper:
Common for digital inputs and used for SINK
mode.
Resistive Load:
5A(N.O.)/3A(N.C.) 240VAC
5A(N.O.)/3A(N.C.) 24VDC
Inductive Load:
1.5A(N.O.)/0.5A(N.C.) 240VAC
1.5A(N.O.)/0.5A(N.C.) 24VDC
To output monitor signal, including in operation,
frequency arrival, overload and etc.
Refer to Pr.02-11~02-12 for programming
Revision August 2008, 03VE, SW V2.04
50%
Pr.02-18
4.7kΩ
50mA
48Vdc
DFM jumper, factory
setting is OC