HID FARGO HDP 6600 User Manual page 80

Powering
Trusted Identities
Setting
Ribbon Print Take-up
Tension
Ribbon Print Supply
Tension
Film Stretch
Compensation
Alternative Mag Verify
Mag Hico DAC Adj
Mag Loco DAC Adj
Resin Heat Adjust
Sleep Time Heater Off
Sleep Time Heater Low
Power
Blush Point
Film Takeup Transfer
Tension
Film Print Supply Tension
Cleaning Rate
Transfer Heat Dissipation
Level
EAT Disable
Beep Disable
eSTANDBY_TEMP
PLT-02931, A.4
Description
This controls the tension of the color ribbon during printing. Adjust the ribbon tension if ribbon wrinkle is
appearing on the card.
Adjustments moderately change the image length.
This controls the supply side tension of the color ribbon during printing. Adjust the ribbon tension if ribbon
wrinkle is appearing on the card.
When printing, the position of the image on the film can vary depending on whether the previous film panel is
used or not. Adjust this setting if the first card after an error is shifted from the rest.
If set to 1, enables a quicker mag verification step of just looking for any data encoded on the card. If set to 0
verifies all data written to the card.
Fine tunes the mag drive current for high-coercivity/super coercivity cards. Adjust if mag verify errors start
occurring with new card stock.
Fine tunes the mag drive current for low-coercivity/medium-coercivity cards. Adjust if mag verify errors start
occurring with new card stock.
Print the resin self-test card.
Use this adjustment for black resin text and barcodes that appear faded or too light or dark.
This setting adjusts how many minutes after the printer goes idle or enters a low power state that the printer
goes into a heater off power state.
This setting adjusts how many minutes after the printer goes idle, the printer goes into a low power state.
The blush point is compensation during printing:
There is no dye transfer.
l
There is no light gray line on a portion of the card.
l
It should be white.
l
Negative adjustments can cause card jams.
l
Positive adjustments can help stop jamming.
l
Adjustments affect flash and smudge.
Important: The film drive sets the baseline for the film tension and should not be adjusted by the reseller
or the end user.
Adjustments moderately change the image length.
This adjustment changes the cleaning rate from 2000 to the new setting.
This setting adjusts when the transfer fan turns on.
0, 1, and 2 - Transfer fan is on only during transfer.
l
3 - Transfer fan turns on when transfer roller comes up to temp.
l
4 - Transfer fan always on when not in sleep mode.
l
Environmentally Adaptive Transfer (EAT) automatically adjusts the transfer temperature based on the
ambient air conditions within the printer.
This is an ON (1) or OFF (0) switch.
Settings can increase or decrease the transfer roller temperature by as much as 68°F (20°C) in extreme
conditions.
This setting disables the beep the printer generates after an EE setting is updated.
This option changes the temperature used when the printer is in standby mode.
FARGO® HDP®6600 High Definition Card Printer/Encoder
80
User Guide
November 2021