HID FARGO HDP 6600 User Manual page 119

Powering
Trusted Identities
Printer Error Message
Flipper Jam
No Flip Module
Wrong Ribbon
Wrong Film
No Ribbon
No Film
Ribbon Out
Film Out
Calibrate Ribbon
Calibrate Film
Calibrate Failed
PLT-02931, A.4
Cause
The flipper table has jammed while either
aligning itself or flipping a card.
The printer does not have flipping
capabilities.
An incorrect ribbon or film is installed, or a
driver setting is incorrect.
No print ribbon or film is installed in the
printer.
OR
Ribbon or film tag information corrupt.
The print ribbon or film installed in the
printer is empty.
The ribbon sensor is not calibrated.
The film sensor is not calibrated.
The ribbon or film sensor failed calibration.
119
FARGO® HDP®6600 High Definition Card Printer/Encoder
Solution
Open the printer flipper module cover.
Clear any cards in the flipper module by
pressing Forward and/or Back on the printer
display.
Ensure that the flipper table can rotate freely.
Close the printer flipper module cover.
Press Resume on the printer display to
continue printing.
To cancel the print, press Cancel on the
printer display or click Cancel Print from the
HID Printer Status Monitor.
Verify the printer has flipper capabilities by
way of the printer display menu.
If flipper capabilities are present, ensure that
the Print Both Sides option in the driver is set
correctly.
Press Resume on the printer display to
continue printing.
To cancel the print, press Cancel on the
printer display or click Cancel Print from the
HID Printer Status Monitor.
Check that the ribbon or film is correct for
the printer and job. Press Resume on the
printer display to continue printing.
To cancel the print, press Cancel on the
printer display or click Cancel Print from the
HID Printer Status Monitor.
Install the correct ribbon or film and press
Resume on the printer display.
Install a new ribbon or film and press
Resume on the printer display.
Cancel the job, open the cover, remove the
ribbon, close the cover, run the ribbon
calibration routine.
Cancel the job, run the film calibration
routine.
Verify the ribbon is removed, the film is
installed, and print cover is closed. Run
calibration again.
User Guide
November 2021