HID FARGO HDP 6600 User Manual page 114

Powering
Trusted Identities
Printer Display Error Message
Wrong Ribbon
Error Message No. 520
See Manual
Error Message No. 431, 432, 433, 452, 457,
485, 547, 548, 549, 550
See Manual
Error Message No. 438
Ribbon Temp Error
Error Message No. 441
Please Install Film and Close Cover
Error Message No. 536
Check Film/Card
Error Message No. 552
Calibrate Failed
Error Message No. 60
Lam No Material
Error Message No. 63
N/A
Error Message No. 64
Remove Card
Error Message No. 68
Remove Lam Cartridge
Error Message No. 210
Wrong Laminate Type
Error Message No. 237
Wrong Laminate Type
Error Message No. 238
PLT-02931, A.4
Cause
The ribbon installed in the printer does not
match the ribbon type selected in the
printer driver.
OR
A self-test job cannot be printed with the
print media installed.
Unspecified system error is detected by
printer firmware.
The print head has become too hot.
The ambient temperature of the printer is
too high.
OR
Sensor failure.
Film is not installed.
Card became jammed in printer during
transfer.
Lam right has failed calibration.
There is no material loaded in the
laminator.
Firmware error in either the printer or the
laminator.
Card in system needs to be manually
removed.
Remove laminate rolls from the laminator.
The wrong laminate type is installed in the
laminator.
The wrong laminate type is installed in the
laminator.
114
FARGO® HDP®6600 High Definition Card Printer/Encoder
Solution
Replace the ribbon in the printer with the type
specified by the printer driver.
Reset printer and try again. If problem
persists, call for technical assistance.
Allow to cool off and try again.
Allow to cool off and try again. If problem
persists, call for technical assistance.
Install the film. Press OK and run the
calibration routine again.
Clear the jam.
Verify materials are installed in all stations.
Close the laminator cover and retry
calibration.
Install the film and press Resume. To cancel
the print, click Cancel Print or press the
Cancel button on the printer.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Open the laminator top cover. Use the printer
button to move the card out of the laminator
or remove the card manually.
Open the laminator top cover. Remove the
film and close the laminator front cover.
Ensure that the appropriate laminator film is
installed and press the Resume button
located on the printer to continue printing. To
cancel, click Cancel Print or press the Cancel
button on the printer.
Ensure that the appropriate laminator film is
installed and press the Resume button on the
printer to continue printing. To cancel, click
Cancel Print or press the Cancel button on
the printer.
User Guide
November 2021