HID FARGO HDP 6600 User Manual page 112

Powering
Trusted Identities
Printer Display Error Message
Headlift Error
Error Message No. 436, 437, 442, 443
Heater Error
Error Message No. 551, 557
Invalid Ribbon
Error Message No. 519
Headlift Error
Error Message No. 553, 554, 555, 556
Headlift Error
Error Message No. 560
Job Data Error
Error Message No. 544
Mag Verify Error
Error Message No. 487
Multiple Feed
Error Message No. 475
No E-card Encoder
Error Message No. 451
No Film
Error Message No. 492
No Flip Module
Error Message No. 482
No Mag Module
Error Message No. 486
PLT-02931, A.4
Cause
This is a problem with the printhead lift.
The transfer heater roller is too hot.
An unauthorized ribbon is installed in the
printer.
There is a problem with the transfer roller
headlift.
There is a problem with the transfer roller
headlift.
The print data sent to the printer is corrupt
or has been interrupted.
Printer could not verify mag write.
OR
The magnetic stripe was not encoded
properly.
Multiple cards were fed into the printer.
You are trying to send encoding data, but
the printer is not configured with this
encoder type.
Film is not installed in the printer.
OR
Film RFID tag is bad.
Two-sided job sent to a one-sided printer.
Mag encoding job sent to the printer
without a mag encoder.
You are trying to send encoding data, but
the printer is not configured with this
encoder type.
112
FARGO® HDP®6600 High Definition Card Printer/Encoder
Solution
Reset the printer and try again.
If this problem persists, call for technical
assistance.
Reset the printer and try again.
If this problem persists, call for technical
assistance.
Get the correct ribbon from your dealer.
Reset the printer and try again. If problem
persists, call for technical assistance.
Reset the printer and try again. If problem
persists, call for technical assistance.
Reset the printer and try again.
If this problem persists, call for technical
assistance.
Check the cards for correct mag stripe
orientation and try again. Verify the mag
coercivity selection in the driver matches that
of the cards
Remove all cards and try again.
To cancel, press Cancel Print.
Install the film and press Resume.
To cancel the print, press Cancel on the
printer display or click Cancel Print from the
HID Printer Status Monitor.
Using the printer display, verify the printer
has flipper capabilities.
If flipper capabilities are present, ensure that
the Print Both Sides option in the printer
driver is set correctly.
Press Resume on the printer display to
continue printing.
To cancel the print, click Cancel Print from
the HID Printer Status Monitor.
To cancel the print, click Cancel Print from
the HID Printer Status Monitor.
User Guide
November 2021