HID FARGO HDP 6600 User Manual page 111

Powering
Trusted Identities
Printer Display Error Message
Film Low
Error Message No. 503
Film Out
Error Message No. 497, 499
Invalid Film
Error Message No. 493
Failed to Initialize
Error Message No. 455, 456
Check Options File
Error Message No. 458
No Film
Error Message No. 498
Ribbon Tag Error
Error Message No. 524
Heater Error
Error Message No. 558, 559
Flipper Jam
Error Message No. 480, 481
Flipper Jam
Error Message No. 488
Head Resistance
Error Message No. 434
See Manual
Error Message No. 435, 440
PLT-02931, A.4
Cause
The HDP film will soon run out.
The HDP film has run out.
The HDP film has been programmed
incorrectly or is damaged.
An error has occurred during printer start
up.
Printer not set up correctly or hardware
failure.
Error reading film tag.
Error reading ribbon tag.
The flattener is too hot.
A card is jammed in the card flipping area
of the printer.
The flipper table is jammed or non-
functional.
A card is jammed in the card flipping area
of the printer.
The EE setting in printer driver for head
resistance is out of range.
A hardware fault has prevented setting the
correct printhead voltage.
111
FARGO® HDP®6600 High Definition Card Printer/Encoder
Solution
If printing a large number of cards, replace
the film now or monitor the printer until the
film is gone and install a new film.
Install a new roll of film and press Resume to
continue or Cancel to reset.
Verify the correct film is installed in the film
cartridge.
Reset the printer and try again. If problem
persists, call for technical assistance.
Reset the printer and try again. If problem
persists, call for technical assistance.
Reset the printer and try again. If problem
persists, call for technical assistance.
Reset the printer and try again. If problem
persists, call for technical assistance.
Reset the printer and try again. If problem
persists, call for technical assistance.
Open the printer flipping module cover.
Clear any cards in the flipping module by
opening the printer cover and pressing the
Forward and/or Back buttons located on the
printer display.
Ensure that the flipper module can rotate
freely. Close the printer flipping module
cover.
Press Resume on the printer display to
continue printing.
To cancel the print, click Cancel Print from
the HID Printer Status Monitor.
Remove the card and clear the jam.
Enter a value for Head Resistance in the EE
settings in the printer driver.
Reset the correct value according to the
steps in 3.5.8 Internal printer
problem persists, call for technical
assistance.
Verify Head Resistance EE setting is correct.
Reset the printer and try again.
If this problem persists, call for technical
assistance.
User Guide
settings. If this
November 2021