HID FARGO HDP 6600 User Manual page 76

Powering
Trusted Identities
Printer settings
Setting
Head Resistance
Print Left Of Form
Image Darkness
PLT-02931, A.4
Description
This is factory set. If the main board or the printhead is replaced, then adjust this number. Locate the
printhead setting number on the bottom of the printhead. The number reads: R=XXXX.
Prints the alignment self-test card.
Adjust the Print Left of Form up or down until the border of the left of form zero line is showing on the edge of
the card.
Measure the density square. Adjust the image density to 65% ± 1%.
Use this option to set the overall darkness of the printed image by increasing or decreasing the amount of
heat the printhead uses while printing.
Use the up and down arrows to increase or decrease the amount of heat.
Important: If the value is set too high, the ribbon may jam or break.
FARGO® HDP®6600 High Definition Card Printer/Encoder
76
User Guide
November 2021