HID FARGO HDP 6600 User Manual page 116

Powering
Trusted Identities
Printer Display Error Message
Laminator Card Jam
Error Message No.337
Laminator Card Jam
Error Message No. 339
Laminator Flipper Jam
Error Message No. 340
Laminator Rotator Jam
Error Message No. 341
Laminator Rotator Jam
Error Message No. 342
Reinstall Lam R Lamininate
Error Message No. 343
Reinstall Lam L Laminate
Error Message No 344
Lam R Lamination Jam
Error Message No. 345
Lam L Lamination Jam
Error Message No. 346
Lam R Laminate Failed to Release
Error Message No. 347
Lam L Laminate Failed to Release
Error Message No 348
Lam R. Cooling
Error Message No. 350
Lam R Laminate Out
Error Message No. 353
Lam L Laminate Out
Error Message No. 354
Lam R and Lam L Laminates Out
Error Message No. 355
Laminator General Error
ERror Message No. 356
Laminator General Error
Error Message No. 357
PLT-02931, A.4
Cause
Card jam POS1 sensor.
Card jam at flipper.
Flipper jam
Card jam at rotator.
Rotator jam
LAM right material not loaded.
LAM left material not loaded.
LAM right lamination jam.
LAM left lamination jam.
LAM right break patch error.
Lam left break patch error.
Laminator heater cooling.
LAM right laminate material out.
LAM left laminate material out.
LAM right and left laminate material out.
Laminator state machine sequence error.
Patch state machine sequence error.
116
FARGO® HDP®6600 High Definition Card Printer/Encoder
Solution
Open the printer and laminator covers and
locate the card. Use the printer buttons to
remove the card or remove the card
manually.
Open printer and laminator covers and locate
the card. Use the printer buttons to remove
the card or remove the card manually.
Reset the printer and try again. Adjust lam
flipper Advanced settings if needed.
Open printer and laminator covers and locate
the card. Use the printer buttons to remove
the card or remove the card manually.
Reset the printer and try again. Adjust Lam
Rotator Advanced settings if needed.
Load or reload material and try again.
Load or reload material and try again.
Load or reload material and try again.
Load or reload material and try again.
Reload material and recalibrate lam sensors.
Reload material and recalibrate lam sensors.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Load new material.
Load new material.
Load new material.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Reset the printer and try again. If this
problem persists, call for techinical
assistance.
User Guide
November 2021