HID FARGO HDP 6600 User Manual page 117

Powering
Trusted Identities
Printer Display Error Message
Lam R Laminate Not at TOF
Error Message No. 358
Lam L Laminate Not at TOF
Error Message No. 359
Lam R Laminate Not Ready
Error Message No. 360
Lam L Laminate Not Ready
Error Message No. 361
Laminate Bad
Error Message No. 371
Laminate Bad
Error Message No. 372
Laminate Bad
Error Message No. 373
Laminate Bad
Error Message No. 374
Laminate Bad
Error Message No. 375
Laminate Bad
Error Message No. 376
Laminate bad
Error Message No. 377
Laminate Bad
Error Message No. 378
Laminator General Error
Error Message No. 379
Reinstall Lam R&L Laminate
Error Message No. 383
Remove Card
Error Message No. 384
IC Lam L Only
Error Message No. 385
Lam R Cooling
Error Message No. 386
Check Lam Power
Error Message No. 455
PLT-02931, A.4
Cause
Lam right material not at TOF.
Lam left material not at TOF.
Lam right material not at POS1.
Lam left material not at POS2.
Right laminate material is bad. Most likely
invalid or corrupt RFID tag.
Left laminate material is bad. Most liely
invalid or corrupt RFID tag.
Right laminate material is bad. Most likely
invalid or corrupt RFID tag.
Let laminate material is bad. Most likely
invalid or corrupt RFID tag.
Right laminate material is bad. Most likely
invalid or corrupt RFID tag.
Left laminate material is bad. Most likely
invalid or corrupt RFID tag.
Right laminate material is bad. Most likely
invalid or corrupt RFID tag
Left laminate material is bad. Most likely
invalid or corrupt RFID tag.
I2c communication to printer has failed.
LAM left and right material not loaded.
Remove card from laminator.
IC cutout only allowed in left lam
Laminator heater error
Lam is connected but not powered.
117
FARGO® HDP®6600 High Definition Card Printer/Encoder
Solution
Calibrate laminator sensors. Adjust Laminate
Top of Form.
Calibrate laminator sensors. Adjust Laminate
Top of Form.
Load or reload material and try again.
Load or reload material and try again.
Change laminator material in right station
and retry.
Change laminator material in left station and
retry.
Change laminator material in right station
and retry.
Change laminator material in left station and
retry.
Change laminator material in right station
and retry.
Change laminator material in left station and
retry.
Change laminator material in right station
and retry.
Change laminator material in left station and
retry.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Load or reload material try again.
Open priinter and laminator covers and
locate the card. Use the printer buttons to
remve the card or remove the card manually.
Remove IC material from the right station.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Check lam power / connections and restart
the printer.
User Guide
November 2021