HID FARGO HDP 6600 User Manual page 113

Powering
Trusted Identities
Printer Display Error Message
No Ribbon
Error Message No. 518, 524
See Manual
Error Message No. 444
Reboot Required
Error Message No. 430
Remove Card
Error Message No. 464
Remove Ribbon
Error Message No. 533
Ribbon Break/Jam
Error Message No. 523, 537
Ribbon Low
Error Message No. 528
Check Ribbon
Error Message No. 530
Ribbon Out
Error Message No. 526, 538
Invalid Ribbon
Error Message No. 519, 531
Unable to Feed
Error Message No. 474
See Manual
Error Message No. 453
Waiting for Data
Error Message No. 454
Wrong Film
Error Message No. 494
PLT-02931, A.4
Cause
No ribbon is installed in the printer.
OR
The ribbon RFID tag is bad.
An error was detected during printing.
Unspecified system error detected by the
printer firmware.
A card is jammed in the print station or card
flipping area of the printer.
The print ribbon is installed and needs to be
removed.
The ribbon is not able to find the next panel
correctly. Check for jams / breaks.
The ribbon will soon run out.
The ribbon is not able to find the next panel
correctly. Check for jams / breaks.
The ribbon has run out.
The ribbon is not installed properly or has
been damaged.
The printer is unable to feed a card from the
card hopper.
Command resulted in an error.
The printer has stopped receiving data from
the PC.
The print film installed in the printer does
not match the film type selected in the
printer driver.
OR
A self-test job cannot be printed with the
print media installed.
113
FARGO® HDP®6600 High Definition Card Printer/Encoder
Solution
Install the correct ribbon and press Resume
on the printer display.
To cancel the print, press Cancel on the
printer display or click Cancel Print from the
HID Printer Status Monitor.
Reset the printer and try again.
If this problem persists, call for technical
assistance.
Reset the printer and try again.
If this problem persists, call for technical
assistance.
Clear the jam and press Cancel.
Remove the ribbon.
If jammed, clear the jam. If broken, repair the
ribbon by taping the ribbon back on to the
take-up core.
Press Resume to continue or Cancel to abort.
If printing a large number of cards, replace
the ribbon now or monitor the printer until the
ribbon is gone and install a new ribbon.
If jammed, clear the jam. If broken, repair by
taping the ribbon back on to the take-up core.
Press Resume to continue or Cancel to abort.
Install a new ribbon and press Resume to
continue.
Verify the correct ribbon is installed in the
ribbon cartridge.
Verify there are cards in the card cartridge.
Verify cards are not stuck together or
jammed, and they are the correct thickness.
Verify correct utility command is sent to the
printer.
Reset the printer and try again.
If this problem persists, call for technical
assistance.
Replace the film in the printer with the type
specified by the printer driver.
A reboot is required.
User Guide
November 2021