HID FARGO HDP 6600 User Manual page 115

Powering
Trusted Identities
Printer Display Error Message
Calibrate Failed
Error Message No. 241
N/A
Error Message No. 245
N/A
Error Message No. 246
N/A
Error Message No. 247
Laminate Bad
Error Message No. 259
Laminate Bad
Error Message No. 260
Laminate Bad
Error Message No. 261
Laminate Bad
Error Message No. 262
Laminator Calibration Error
Error Message No. 329
Check Lam Hot Roller Lift
Error Message No. 331
Check Lam Hot Roller Lift
Error Message No. 332
Heater Error - Cycle Power
Error Message No. 333
Heater Error - Cycle Power
Error Message No. 334
Laminator Input Card Jam
Error Message No. 335
Laminator Card Jam
Error Message No. 336
PLT-02931, A.4
Cause
Lam left has failed calibration.
Laminator communication error.
Laminator comunication error.
Laminator communication error.
Right laminate material is bad. Most likely
invalid or corrupt RFID tag.
Left laminate material is bad. Most likely
invalid or corrupt RFID tag.
The material loaded in the right lam is not
suitable for the right lam.
The material loaded in the left lam is not
suitable for the left lam.
Error lid open.
Lift retract.
Lift engage (pressure).
Laminator heater error.
Laminator heater IR sensor error.
No card input sensor.
Card jam input sensor
115
FARGO® HDP®6600 High Definition Card Printer/Encoder
Solution
Verify materials are installed in all stations.
Close the laminator lid and retry calibration.
Verify that the firmware is up-to-date and all
cables are plugged in.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Install valid material.
Install valid material.
Install valid material.
Install valid material.
Close the laminator cover.
Open the laminator cover and press on the
top of the lamination assembly to verify the
assembly is properly seated.
Open the laminator cover and press on the
top of the lamination assembly to verify the
assembly is propertly seated.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Reset the printer and try again. If this
problem persists, call for technical
assistance.
Open the printer and laminator covers and
locate the card. Use the printer buttons to
remove the card or remove the card
manually.
Open the printer and laminator covers and
locate the card. Use the printer buttons to
remove the card or remove the card
manually.
User Guide
November 2021