OnRobot 2FGP20 User Manual page 21

SW INSTALLATION
Device info
Dropdown menu to select a device-robot communication channel: Discover the connected
devices.
Use the reload button
NOTE:
After setting up the device the changes need to be saved to be part of the
current installation.
For the e-Series UR robots tap on the Save button
use the Save Installation button
For the CB3 UR robots use the Save button
NOTE:
To use the newly discovered devices you might need to restart PolyScope. To
do that simply press the Restart now button. Remember to save it before, if
there are any unsaved changes in your program or settings.
OnRobot products are checked after the robot is restarted and the saved
settings are restored while loading a program. That check could take up to 5
seconds via the Quick Changer for I/O. Therefore make sure to wait at least 5
seconds before you start your program. To make sure that the device is
connected check the Device info.
If the connected OnRobot product is changed, always go to the Device info to
check if the change was successful.
CAUTION:
After any error message is shown that is related to the connection to our
devices, please go to the Device info to make sure that the right settings (e.g.:
TCP) are used.
No connection: If you want to use OnRobot URCap and there are no connected devices,
select No connection from the dropdown menu and no error message will show up.
Load multiple devices: The
environment, even if the device is not connected to the robot. When you change between
loaded devices, the robot does not require a restart but you should press the reload button
to refresh the detected devices.
WARNING:
When multiple devices are activated, you may experience slow URCap
operation. In this case, activate only the devices that you use. It is
recommended to activate up to two devices at the same time.
to find new available devices.
automatically loads the selected devices to the UR
(from the top menu and
.
.
21