Operation - GASLAND chef Pro Series Instruction Manual

17 41

Operation

Problem
F03 or F04 Error
appears in the
display window.
Other F_ Error
appears in the
display window.
The oven display
does not illuminate.
Cooling fan
continues to run
after oven is
turned off.
Oven door is locked
and will not release,
even after cooling.
Oven is not heating.
Oven is not
cooking evenly.
Oven light is not
working properly.
Oven light stays on.
Cannot remove
lens cover on light.
1 (844) 538-7890
support@gaslandchef.com
Possible Cause
A problem with
latch mechanism
occurred.
The oven
components
have not cooled
sufficiently.
No power going to
the oven.
Oven Mode or
Temperature not
selected.
Oven rack is not in
correct position.
Convection Bake
Mode
Light bulb is loose
or burned out.
Oven door does not
close completely.
Lens cover is dirty.
Turn off power at the main power supply(fuse
or breaker box), wait a few seconds and turn
it back on again. The oven should run a latch
auto–test. If condition persists, note the code
number and call an authorized service center.
Turn off power at the main power supply
(fuse or breaker box), wait a few seconds and
turn it back on again. If condition persists,
note the code number and call an authorized
service center.
Turn off power at the main power supply
(fuse or breaker box). Turn breaker back on.
If condition persists, call an authorized
service center.
The fan turns off automatically when the
electronic components have cooled
sufficiently.
Turn the oven off at the circuit breaker and
wait a few seconds. Turn breaker back on.
The oven should reset itself and will be
operable.
Turn on power at the main power supply(fuse
or circuit breaker box). If condition persists,
call a qualified electrician.
Press cooking option on keypad to select the
oven mode and temperature.
Refer to cook charts starting on page 23 for
recommended rack position.
Always reduce recipe temperature by 25°F
(15°C) when baking with Convection Bake
mode.
Replace or reinsert the light bulb if loose or
defective. Touching the bulb with fingers may
cause the bulb to burn out.
Check for obstruction in oven door. Check to
see if hinge is bent or door switch is broken.
There may be a soil build-up around the lens
cover. Wipe lens cover area with a clean dry
towel prior to attempting to remove the lens
cover.
www.gaslandchef.com
3330-A Marathon Ct Charleston, SC 29418
Solution