Safety; Safety Information - Inxpect SBV System Series Instruction Manual

2. SAFETY

2.1 Safety information

2.1.1 SAFETY MESSAGES
Warnings related to the safety of the user and of the equipment as envisaged in this document are as follows:
WARNING! indicates a hazardous situation which, if not avoided, may cause death or serious injury.
NOTICE: indicates obligations that if not observed may cause harm to the equipment.
2.1.2 SAFETY SYMBOLS ON THE PRODUCT
This symbol marked on the product indicates that the manual must be consulted. In particular, pay
attention to the following activities:
wiring of the connections (see "Terminal blocks and connector pin-outs" on page 82 and "Electrical
l
connections" on page 84)
cable operating temperature (see "Terminal blocks and connector pin-outs" on page 82)
l
control unit cover, which was subjected to a low energy impact test (see "Technical data" on page 79)
l
2.1.3 PERSONNEL SKILLS
The recipients of this manual and the skills required for each activity presented herein are as follows:
Recipient
Machinery Defines which protective devices should
l
manufacturer be installed and sets the installation
specifications
Installs the system
Protection
l
Configures the system
system installer
l
Prints configuration reports
l
Performs maintenance on the system
Machinery
l
maintenance
technician
2.1.4 SAFETY ASSESSMENT
Before using a device, a safety assessment in accordance with the Machinery Directive is required.
The product as an individual component fulfills the functional safety requirements in accordance with the
standards stated in "Standards and Directives" on page 11. However, this does not guarantee the functional
safety of the overall plant/machine. To achieve the relevant safety level of the overall plant/machine's required
safety functions, each safety function needs to be considered separately.
8
Assignments
SBV System Series | Instruction manual v1.2 DEC 2021 | SAF-UM-SBVBus-en-v1.2 | © 2021 Inxpect SpA
Skills
Knowledge of significant hazards of the
l
machinery that must be reduced based on
risk assessment.
Knowledge of the entire machinery safety
l
system and the system on which it is
installed.
Advanced technical knowledge in the
l
electrical and industrial safety fields
Knowledge of the dimensions of the
l
dangerous area of the machinery to be
monitored
Receives instructions from the machinery
l
manufacturer
Advanced technical knowledge in the
l
electrical and industrial safety fields