Inxpect SBV System Series Instruction Manual page 22

3. Get to know SBV System Series
3.4.3 Access
The application can be downloaded free of charge at www.inxpect.com/industrial/tools.
Some functions are password protected. The admin password can be set through the application and then saved
on the control unit. The available functions according to access type are presented as follows:
Display the system status (Dashboard)
l
Display the sensors configuration (Configuration)
l
Restore factory default settings, if not using Ethernet connection (Settings > General)
l
Back up the configuration (Settings > General)
l
Synchronize more control units (Settings > Multi-control unit synchronization)
l
Validate the system (Validation)
l
Restore factory default settings, if using Ethernet connection (Settings > General)
l
Download the system log and display reports (Settings > Activity History)
l
Check the current checksum for each dynamic configuration (Settings >
l
Configuration checksum)
Configure the system (Configuration)
l
Load a configuration (Settings > General)
l
Change the admin password (Settings > Account)
l
Update the firmware (Settings > General)
l
Show and change the network parameters - if available (Settings > Network
l
Parameters)
Show and change the Modbus parameters - if available (Settings > Modbus
l
Parameters)
Show and change the Fieldbus parameters - if available (Settings > Fieldbus
l
Parameters)
3.4.4 Main menu
Page
Dashboard
Configuration
Validation
Settings
REFRESH
CONFIGURATION
22
Available functions
Display main information on the configured system.
Note: the messages shown are those in the log file. To know the meaning of the
messages, see the chapters on logs in "Maintenance and troubleshooting" on
page 64.
Define the monitored area.
Configure the sensors and the detection fields.
Define the dynamic configurations
Start the validation procedure.
Note: the messages shown are those in the log file. To know the meaning of the
messages, see the chapters on logs in "Maintenance and troubleshooting" on
page 64.
Configure the sensors.
Choose the detection fields dependency.
Enable the anti-tampering functions.
Synchronize more control units.
Configure the inputs and outputs function.
Configure, show and change the network parameters (if available).
Configure, show and change the Modbus parameters (if available).
Configure, show and change the Fieldbus parameters (if available).
Update the firmware.
Perform the configuration backup and load a configuration.
Download the log.
Other general functions.
Refresh configuration or ignore unsaved changes.
SBV System Series | Instruction manual v1.2 DEC 2021 | SAF-UM-SBVBus-en-v1.2 | © 2021 Inxpect SpA
Function
Access type
without password
with password