Yale 524150797 Maintenance Manual page 54

General
To install the drive unit cover, place the bottom of the
drive unit cover onto the frame and position the lower
edges partially into the lower retaining clips. Align the
holes in the cover with the mounting studs attached to
the frame. Push the top of the cover partially into the
upper retaining clips. Do not push either edge of the
cover in completely in before starting all edges into
the proper place. When the cover is aligned and
started properly, press the cover completely into the
retaining clips. Install the two nuts securing the cover
to the frame.
ACCESSING THE DRIVE UNIT
COMPARTMENT
The drive unit compartment is concealed behind a
molded cover which fits securely around the drive unit
and steer support to the frame.
1. DRIVE UNIT COMPARTMENT COVER
2. ALIGNMENT PIN
2
Figure 2. Drive Unit Compartment Cover A245
Remove the drive unit cover, starting at the top left
edge of the cover and with both hands pull the cover
away from the frame until the cover kicks out from the
retaining clips. Repeat this for the right side of the
cover. Work around the edge of the cover until free
from the truck. See Figure 2.
To install the drive unit cover, place the bottom of the
drive unit cover onto the frame and position the lower
edges partially into the lower retaining clips. Align the
holes in the cover with the alignment pin attached to
the frame. Push the top of the cover partially into the
upper retaining clips. Do not push either edge of the
cover in completely in before starting all edges into
the proper place. When the cover is aligned and
started properly, press the cover completely into the
retaining clips.
3. RETAINING CLIPS
4. FRAME
0620 YRM 1513