Remove; Install - Yale 524150797 Maintenance Manual

2200 YRM 1508

Remove

Refer to Figure 4 for the following procedures.
1. Remove contactor as described in Pump
Contactor, Replace.
2. Remove screws (4) that fasten the top cover to
the coil and frame.
3. Remove cover, moving contact (2), and return
spring.
4. Remove capscrews, washers, and nuts that make
up the fixed contactor tips (1) from the top cover.
5. If a coil will be replaced, remove coil frame and
remove end cap from frame.
6. Remove coil from frame.

Install

1. Install new coil on frame and install end cap.
2. Install moving contact (2) and return spring.
3. Install capscrews, washers, and nuts that make
up the fixed contactor tips (1) to the top cover.
NOTE: Check that the moving contactor and springs
move freely without binding.
4. Install cover to coil and frame using screws (4).
5. Install contactor assemblies on the lift truck as
described in Pump Contactor, Replace.
1. FIXED CONTACTS
2. MOVING CONTACTS
3. TOP COVER
4. SCREW
5. RETURN SPRING
6. COIL AND FRAME
7. END CAP
Figure 4. Contactor
Repairs
7