Control Handle
1. JUMPER TERMINALS (SV2)
2. HORN SWITCH (S1)
3. THUMBWHEEL SWITCH (MAGNETIC HOLDER)
1.
Partially assemble the control handle head. Refer
to Figure 14.
2.
Connect the control handle card wiring, verify that
the battery is connected, and turn the key switch
to the ON position.
3.
The LED will display the program setting for
approximately five seconds. See Figure 11. The
proper control handle card setting for this model
14
4. LED DISPLAY SCREEN
5. BELLY SWITCH (S)
6. TURTLE SWITCH (S2)
Figure 11. Control Handle Card
is 7. If the correct number is displayed on the
LED, the control handle card is configured
correctly.
4.
To begin configuring the card, turn the key switch
to the OFF position.
5.
Move the jumper from P (park) to C (configure).
See Figure 12.
2200 YRM 1508