Assemble - Yale 524150797 Maintenance Manual

Control Handle
A. CALIBRATION MODE
B. CALIBRATION MODE
C. ROTATION RIGHT SEGMENT COMPLETE
D. ROTATION LEFT SEGMENT COMPLETE
E. ALL SEGMENTS COMPLETE AND SAVED
Figure 13. LED Views
NOTE: "Rotation Right" direction is specified by label
printed on face of card.
4. Rotate the thumbwheel in the "Rotation Right"
direction (toward the forks) and hold to the
mechanical stop. Press the left side lift button.
5. The LED screen will change to show this segment
complete. See Figure 13, view C. Release the
thumbwheel so it returns to the neutral position.
NOTE: "Rotation Left" direction is specified by label
printed on face of card.
6. Rotate the thumbwheel in the "Rotation Left"
direction (toward the operator) and hold to the
mechanical stop. Press the left side lower button.
7. The LED screen will change to show this segment
complete. See Figure 13, view D. Release the
thumbwheel so it returns to the neutral position.
16
8. Move the jumper from T (teach) to P (park). See
Figure 12.
9. The LED screen will change to show a decimal
beside the completed segments indicating they
have been saved. See Figure 13, view E.
10. Use diagnostic from handset to verify the
"Throttle" output 95% and above for both
directions.
11. Recycle the key switch OFF and ON and test all
truck functions for proper operation.

ASSEMBLE

1. Install control handle card in the upper half of
control handle. See Figure 14.
NOTE: When inserting knobs, make sure that flange
on one of the butterfly knobs inserts between spring on
handle.
2. Slide shaft and butterfly knob into control handle
card. Be careful not to rotate the shaft inside the
control handle card.
3. Connect the switches and wire harness
connectors.
4. Plug handle wiring harness into control handle
card.
CAUTION
DO NOT force the upper half onto the lower half as
this will cause damage to the retaining hooks of
the upper half.
5. To install upper half of handle onto the lower half:
a. Tip the upper half up and align the hooks under
the auto-reverse switch.
b. Lower the upper half onto the lower half.
6. Install capscrews to retain upper half of control
handle to lower half.
7. Connect battery cable the test control handle
operation.
2200 YRM 1508