Disassemble; Assemble; Install - Yale 524150797 Maintenance Manual

Rear Link and Load Wheel Assembly

DISASSEMBLE

1. Remove the bushings from the rear link. See Fig-
ure 1 and Figure 2.
2. Remove the load wheel assembly from the rear
link. See Load Wheel in this section to service the
load wheel assembly.

ASSEMBLE

1. Press new bushings into the rear link. Using the
grease fitting hole as a guide, align the groove in
the bushing with the hole in the rear link casting.
2. Assemble the load wheel assembly. See Load
Wheel in this section for assembly instructions.

INSTALL

1. Align the pull rod with the rear link and install the
pull rod pivot pin. Align the retaining pin hole in
the pivot pin with the opening in the casting. In-
stall the retaining pin into the rear link casting and
through the hole in the pull rod pivot pin.
2. Align the rear link with the fork frame and install
the rear link pivot pin. Install the retaining cap-
screw into the fork frame.
3. Lubricate all linkage pivot pins with multipurpose
grease. See the Recommended Schedule of
Maintenance in the section
• Periodic Maintenance 8000YRM1510
for lift truck model A249
• Periodic Maintenance 8000YRM1666
for lift truck model A245
6
4. Connect the battery and press the lift button to
raise the forks.
5. Remove the blocks from under the forks and the
drive tire. Lower the truck.
6. Test the operation of the lift truck before returning
the truck to service.
1. ROLL PIN
2. PULL ROD PIN
3. PULL ROD
4. LOAD WHEEL ASSEMBLY
5. REAR LINK
Figure 6. Pivot Pin Removal
4000 YRM 1509