Dtc 60050 - Emerrevr; Dtc 60210 - Emerrevr - Yale 524150797 Maintenance Manual

ELECTRICAL SYSTEM
CODES

DTC 60050 - EmerRevr

DTC 60210 - EmerRevr

POSSIBLE CAUSE
A. START UP SEQUENCE
B. BELLY SWITCH SEQUENCE
C. CONTROLLER WIRING FAULT
D. FAULTY TILLER CONTROL CARD
COMPONENT OPERATIONAL CHECK
NOTE: Always check battery condition and state of charge before performing electrical troubleshooting. A faulty
or low charged battery will cause electrical features to not operate as designed and give incorrect readings while
performing electrical tests.
PROCEDURE OR ACTION:
1. Conduct a visual inspection of all connectors/wiring associated with the fault code.
Are any faults detected/observed?
YES: Repair/replace connector or wiring associated with faults found. Refer to the appropriate Electrical
System YRM .
NO: Proceed to Step 2.
2. Re-key the vehicle.
Is the code still present?
YES: Proceed to Step 3.
NO: Problem may be intermittent.
3. Using the PC Service Tool, locate input diagnostics and view belly switch input.
Is belly switch operational?
YES: fault may be intermittent. Inspect belly switch for damage.
NO: Proceed to Cause A.
CAUSE A - START UP SEQUENCE
PROCEDURE OR ACTION:
1. This fault code will occur if operator commands traction while traction interlock sensor is off or if operator is
operating tiller arm outside of operational range. Reference the Electrical System YRM to identify tiller arm
operational range and to verify actual cause of fault.
Was fault due to interlock or tiller arm operation?
YES: Clear fault.
NO: Proceed to Cause B.
Check the Service Manual section in Yale Axcess Online for possible updates and check pertinent Bulletins
Please refer to the end of this procedure for supporting diagrams.
NOTE
Diagnostic Trouble Codes
9030-20-63