2200 YRM 2030
Mode Setting Check
NOTE: Mode settings can be checked by connecting
the battery charger to a power source and watching
the LED display while connected to the battery, refer-
ence Table 2 for LED display of mode setting. If the
battery voltage is below 12V, no lights illuminate.
Mode setting information is only displayed for four
seconds after initial power source is connected.
MODE SETTING
1
2
4
5
13
15
16
Figure 5. Switch Position Mode Chart
Table 2. LED Charge Mode Indicator
LED 1
LED 2
Off
Off
Off
Off
Off
Off
Off
Off
Off
Flashing
Off
Flashing
Flashing
Off
AccuSense
Modes are set by the sequence of the mode switches.
Tampering with the Charging Mode Label voids war-
ranty.
NOTE: If the charger has been Field Reprogrammed,
during first time charger is used, startup time can take
up to 10 minutes. The LEDs will not flash and the
charger will appear to be frozen. Do not unplug the
charger as it rebuilds internal database information.
LED 3
LED 4
Off
Off
Flashing
Flashing
Flashing
Flashing
Flashing
Flashing
Off
®
Q-Series Charger
LED 5
Off
Flashing
Off
Off
Off
Off
Flashing
Off
Flashing
Flashing
Off
Off
3