Geometry Reset - Barco MCM-100S User Manual

11. Advanced operation
Image 11-18
3. Press ENTER to select Change Mode.
The selected (PixelsX or PixelsY) edit box is highlighted.
4. Enter a new value.
Image 11-19

11.1.9 Geometry reset

Description
All geometry adjustments can be reset at once or you can decide to restore the Geometry setting to one of the modes. This can be
done from the Geometry Edit menu.
• Reset all levels: all geometry adjustments are deleted, ending up with a non distorted image where all geometry adjustment
values are 0!
• Restore to a mode: All geometry adjustments of the lower modes are reset (all geometry correction values of these modes
are set to 0). The correction values of the selected mode and all higher modes are retained.
E.g. if you select Restore to 3x3 all adjustment values in modes 5x5, 9x9, 17x17 and 33x33 are set to 0.
Resetting all levels or restoring to a mode
1. In the OSD, navigate to Geometry > Edit > Reset > Restore to 3x3 or 5x5 or 9x9 or 17x17 or Reset all levels and press ENTER
to select.
92 R5905187 MCM-100S 05/06/2012