Barco MCM-100S User Manual page 134

12. Expert operation
0 5 10 15 20
1 6 11 16 21
2 7 12 17 22
3 8 13 18 23
4 9 14 19 24
Image 12-42
Anchor point numbering: left and right edges
Level hierarchy
Similar to Geometry levels, Soft Edge adjustment has hierarchy levels.
Each level represents a group of anchor points and interacts with other levels: moving an anchor point on a certain level affects
points in the levels underneath. Therefor it is required to start shaping the Soft Edge area from the highest level and go to lower
levels while completing the procedure.
In Level 1, the four corners of the default soft edge zone act as anchor points. Moving any of them affects the whole area. When
moving an anchor point of Level 6, only a smaller part of the whole area is affected. The images below show the levels and corre-
sponding anchor points in the left side Soft Edge area and an example of a weirdly shaped left side Soft Edge + blanking.
130
20 15 10
21 16 11
22 17 12
23 18 13
24 19 14
R5905187 MCM-100S 05/06/2012
5 0
6 1
7 2
8 3
9 4