Barco MCM-100S User Manual page 104

11. Advanced operation
When stereo option is disabled, sources with a refresh rate of 100 Hz or 120 Hz will not be displayed.
Stereo Sources
Stereo option needs to be enabled. If not enabled, stereo sources will not be displayed.
When a stereo source is connected to the projector following settings can change the way it is displayed :
• Full screen synchronous representation
Following illustrations give an overview on how a stereo source will be displayed in function of its vertical refresh rate and for the
different settings mentioned above.
SOURCE = stereo
@2xf
ASYNC
50
ASYNC:
@100Hz (low mode)
@120Hz (high mode)
Image 11-36
Stereo source : Full screen synchronous representation ON
SOURCE = stereo
48
Image 11-37
Stereo source : Full screen synchronous representation OFF
Stereo always active and True motion reproduction
Switching the stereo mode to Always active or switching true motion reproduction to On will need an extra confirmation within 30
seconds in order to avoid that the OSD menus of the device are not accessible any more when the projector is not stereo compliant.
Image 11-38
100
FULL SCREEN SYNCHRONOUS MODE = on FULL SCREEN SYNCHRONOUS MODE = on
Stereo mode = auto or always active
@2xf
ASYNC ASYNC
60
SYNC:
@50Hz (±0.5Hz) or @60Hz (±0.5Hz) but displayed @100Hz or @120Hz
@100Hz (±0.5Hz) or @120Hz (±0.5Hz)
FULL SCREEN SYNCHRONOUS MODE = off
Stereo mode = auto or always active
@100Hz (low mode) or @120Hz (high mode)
ASYNC
100
ASYNC
ASYNC
120
f(Hz)
120
f(Hz)
R5905187 MCM-100S 05/06/2012