Barco MCM-100S User Manual page 117

Shifting the image electronically
1. In the OSD, navigate to Geometry > Edit > Shift... and press ENTER to select.
Image 12-16
Image 12-17
Note: By default the Adjust mode is selected.
2. Do you want to shift the image a few pixels only?
If yes, Use the arrow keys on the RCU to shift the image and go to the last step of this procedure.
If no, Perform the steps below.
3. Press ENTER to navigate to Edit mode if you want to shift the image over a wider range.
R5905187 MCM-100S 05/06/2012
12. Expert operation
113