Barco MCM-100S User Manual page 79

Parameter
Vertical Active lines
Vertical Start lines
Aligning a source: work flow
Source alignment is done through the Edit Custom file dialog box.
1. Set Active pixels and Active lines;
2. Adjust Total pixels;
3. Adjust Start pixels;
4. Adjust Start lines.
Editing a Custom image file
1. In the OSD, navigate to Image files > Edit... and press ENTER to select.
Image 10-59
2. In the Edit Custom file dialog box, change the following parameters to your wishes. In case of doubt, leave the parameters to
the default values.
- Active horizontal pixels;
- Active vertical lines;
- Total horizontal pixels;
- Horizontal start in pixels;
- Vertical start in lines.
3. Exit the menu.
Advanced settings for Video sources
The advanced button enables the advanced settings for a video source.
Image 10-60
The Comb filter is by default enabled.
The AGC hold interval is the time interval in which the AGC is inhibited (AGC hold = no update in video amplitude measurement);
the advanced parameter allows to choose a short or long hold interval.
R5905187 MCM-100S 05/06/2012
Editable in advanced mode in case of
DVI signal (Y/N)
Y
Y
video signal
Image 10-61
HI AGC Hold interval
10. Basic operation
Advised way to set the value
The total amount of lines per frame. This
can be know from the native resolution of
the source. E.g. 1080 in case of full HD
signal.
Use a native outline pattern generated
by the source: both the top side and the
bottom side of the outline pattern must
be visible.
frame blanking
egalisation
HI
video signal
75