Barco MCM-100S User Manual page 91

Image 11-7
This Geometry Distortion edit dialog acts as an intuitive user interface to perform all geometry adjustments on the fly. Each individual
anchor point can be selected and moved to the desired location in real time.
Depending on the geometry mode, the dialog box may slightly differ; the dialog box below is for a 2x2 mode adjustment.
Image 11-8
The table below describes every item in the Geometry Distortion edit dialog box.
Field/Adjustment
Level 2x2
Column
Row
PixelsX
PixelsY
R5905187 MCM-100S 05/06/2012
Description
Denotes the selected geometry
adjustment mode.
Column number corresponding to the
selected anchor point.
Row number corresponding to the
selected anchor point.
This slider bar and edit box are used to
define the new position of the anchor
point along the X axis, relative to its
original position.
This slider bar and edit box are used to
define the new position of the anchor
point along the Y axis, relative to its
original position.
11. Advanced operation
Notes
Level can be 2x2, 3x3, 5x5, 9x9, 15x15
or 33x33.
This number refers to the 33x33 grid.
This number refers to the 33x33 grid.
In table front mode, and if Axislink is set
to off, a positive value moves the anchor
point to the right side.
High values can introduce some clipping
effects.
In table front mode, and if Axislink is set
to off, a positive value moves the anchor
point down.
High values can introduce some clipping
effects.
87