Control And Indication Interfaces; W_Disable1 - Quectel RM510Q-GL Hardware Design

4.5. Control and Indication Interfaces

The following table shows the pin definition of control and indication pins.
Table 20: Pin Definition of Control and Indication Interfaces
Pin No. Pin Name
8

W_DISABLE1#

26 W_DISABLE2#
10 WWAN_LED#
23 WAKE_ON_WAN#
25 DPR*
38 SDX2AP_STATUS*
68 AP2SDX_STATUS*
4.5.1. W_DISABLE1#
The module provides a W_DISABLE1# pin to disable or enable airplane mode through hardware
operation. W_DISABLE1# is pulled up by default. Driving it LOW will set the module to airplane mode. In
airplane mode, the RF function will be disabled.
The RF function can also be enabled or disabled through AT commands. The following table shows the
AT command and corresponding RF function status of the module.
Table 21: RF Function Status
W_DISABLE1# Level
High Level
RM510Q-GL_Hardware_Design
I/O Description
Airplane mode control.
DI, OD Pulled up by default.
Active LOW.
GNSS disable control.
DI, OD Pulled up by default.
Active LOW.
RF status indication LED
DO, OD
Active LOW.
Wake up the host.
DO, OD
Active LOW
Dynamic power reduction.
DI, PU
High level by default.
DO, PD Status indication to AP
DI, PD Status indication from AP
AT Commands
AT+CFUN=1
AT+CFUN=0
AT+CFUN=4
RM510Q-GL Hardware Design
RF Function Status
Enabled (RF operation allowed)
Disabled (no RF operation allowed)
5G Module Series
DC Characteristics
1.8/3.3 V
1.8/3.3 V
VCC
1.8 V
1.8 V
1.8 V
48 / 87