Control And Indication Interfaces; W_Disable1 - Quectel RM510Q-GL Hardware Design

The clock and mode can be configured by AT command, and the default configuration is master mode
using short frame synchronization format with 2048 kHz PCM_CLK and 8 kHz PCM_SYNC. See
document [4] for details about AT+QDAI command.

4.5. Control and Indication Interfaces

The following table shows the pin definition of control and indication pins.
Table 20: Pin Definition of Control and Indication Interfaces
Pin No. Pin Name
8

W_DISABLE1#

26 W_DISABLE2#
10 WWAN_LED#
23 WAKE_ON_WAN#
25 DPR*
38 SDX2AP_STATUS
68 AP2SDX_STATUS
4.5.1. W_DISABLE1#
The module provides a W_DISABLE1# pin to disable or enable airplane mode through hardware
operation. W_DISABLE1# is pulled up by default. Driving it low will set the module to airplane mode. In
airplane mode, the RF function will be disabled.
The RF function can also be enabled or disabled through software AT commands. The following table
shows the RF function status of the module.
RM510Q-GL_Hardware_Design
I/O Description
Airplane mode control.
DI, OD Pulled up by default.
Active LOW.
GNSS disable control.
DI, OD Pulled up by default.
Active LOW.
Indicate RF status of the module.
DO,OD
Open drain.
Wake up the host.
DO,OD
Open drain.
Dynamic power reduction.
DI, PU
High level by default.
DO, PD Status indication to AP
DI, PD Status indication from AP
5G Module Series
RM510Q-GL Hardware Design
DC Characteristics
1.8/3.3 V
1.8/3.3 V
VCC
1.8 V
1.8 V
1.8 V
47 / 88