Reference Design Of Pcie - Quectel RM510Q-GL Hardware Design

4.3.3. Reference Design of PCIe

The following figure shows a reference circuit for the PCIe interface.
Host
PCIE_REFCLK_P
PCIE_REFCLK_M
PCIE_TX_P
PCIE_TX_M
PCIE_RX_P
PCIE_RX_M
PCIE_WAKE_N
PCIE_CLKREQ_N
PCIE_RST_N
NOTE: The voltage level VCC_IO_HOST of these three signals depend on the host side due to open drain.
To ensure the signal integrity of PCIe interface, AC coupling capacitors C3 and C4 should be placed close
to the host on PCB. C1 and C2 have been embedded into the module, so do not place these two
capacitors on your schematic and PCB.
The following principles of PCIe interface design should be complied with to meet the PCIe specification.
⚫
Keep the PCIe data and control signals away from sensitive circuits and signals, such as RF, audio,
crystal and oscillator signals.
⚫
Add a capacitor in series on Tx/Rx traces to prevent any DC bias.
⚫
Keep the maximum trace length less than 300 mm.
⚫
Keep the length matching of each differential data pair (Tx/Rx) less than 0.7 mm for PCIe routing
traces.
⚫ Keep the differential impedance of PCIe data trace as 85 Ω ±10 %.
⚫
You must not route PCIe data traces under components or cross them with other traces.
RM510Q-GL_Hardware_Design
R4 0Ω
R5 0Ω
C3 220 nF
C4 220 nF
VCC_IO_HOST
R1 R2 R3
10k 10k NM/10k
R6
10k
Figure 19: PCIe Interface Reference Circuit
RM510Q-GL Hardware Design
PCIE_REFCLK_P
55
PCIE_REFCLK_M
53
PCIE_RX_P
49
PCIE_RX_M
47
PCIE_TX_P
43
PCIE_TX_M
41
PCIE_WAKE_N
54
PCIE_CLKREQ_N
52
PCIE_RST_N
50
5G Module Series
Module
C1 220 nF
C2 220 nF
BB
44 / 87