Table of Contents
Advertisement
Low Level
4.5.2. W_DISABLE2#
The module provides a W_DISABLE2# pin to disable or enable the GNSS function. The W_DISABLE2#
pin is pulled up by default. Driving it LOW will disable the GNSS function. The combination of
W_DISABLE2# pin and AT commands can control the GNSS function.
Table 22: GNSS Function Status
W_DISABLE2# Level
High Level
High Level
Low Level
Low Level
A simple level shifter based on diodes is used on W_DISABLE1# pin and W_DISABLE2# pin which are
pulled up to a 1.8 V voltage in the module, as shown in the following figure, so the control signals (GPIO)
of the host device could be at 1.8 V or 3.3 V voltage level. W_DISABLE1# and W_DISABLE2# are active
LOW signals, and a reference circuit is shown as below.
Host
GPIO
GPIO
Note: The voltage level of VCC_IO_HOST could be 1.8 V or 3.3 V typically.
Figure 24: W_DISABLE1# and W_DISABLE2# Reference Circuit
RM510Q-GL_Hardware_Design
AT+CFUN=1
AT+CFUN=0
AT+CFUN=4
AT Commands
AT+QGPS=1
AT+QGPSEND
AT+QGPS=1
AT+QGPSEND
VCC_IO_HOST
R3
R4
10k
10k
RM510Q-GL Hardware Design
Disabled (no RF operation allowed)
GNSS Function Status
Enabled
Disabled
W_DISABLE2#
W_DISABLE1#
5G Module Series
Module
VDD 1.8V
R1
R2
100k
100k
26
BB
8
49 / 87
Advertisement
Table of Contents
