Control And Indication Interface; W_Disable1 - Quectel EM06 Series Manual

NOTES
It is recommended to add an RC (R = 22 Ω, C = 22 pF) circuit on the PCM lines, especially for
1.
PCM_CLK.
2. EM06 series module works as a master device pertaining to I2C interface.

3.10. Control and Indication Interface

The following table shows the pin definition of control and indication interfaces.
Table 12: Pin Definition of Control and Indication Interfaces
Pin Name
WWAN_LED#
WAKE_ON_WAN#

W_DISABLE1#

1)
W_DISABLE2#
DPR
NOTE
1)
means GNSS enablement control function is under development.
3.10.1. W_DISABLE1#
The module provides a W_DISABLE1# signal to disable or enable the airplane mode through hardware
method. The W_DISABLE1# pin is pulled up by default. When AT+CFUN=1, driving W_DISABLE1# to
low level will enable the airplane mode in which the RF function is disabled.
EM06_Series_Hardware_Design
Pin No. I/O Power Domain
10 OD 3.3 V
23 OD 1.8 V
8 DI 1.8/3.3 V
26 DI 1.8/3.3 V
25 DI 1.8 V
LTE-A Module Series
EM06 Series Hardware Design
Description
An open collector and active low signal.
Indicates the RF status of the module.
An open collector and active low signal.
Wakes up the host.
Airplane mode control. Active low.
GNSS enablement control. Active low.
Dynamic power reduction. High level by
default.
37 / 69