Control And Indication Interfaces; W_Disable1 - Quectel RM500Q-AE Manual

3.9.3.11.

Control and Indication Interfaces

The following table shows the pin definition of control and indication pins.
Table 131312: Pin Definition of Control and Indication Interfaces
Pin No. Pin Name
8

W_DISABLE1#*

10 WWAN_LED#*
23 WAKE_ON_WAN#*
25 DPR*
26 W_DISABLE2#*
38 SDX2AP_STATUS
68 AP2SDX_STATUS
NOTE
"*" means under development.
3.9.1.3.11.1. W_DISABLE1#*
The module provides a W_DISABLE1# pin to disable or enable airplane mode through hardware
operation. The W_DISABLE1# pin is pulled up by default. Driving it low will set the module to airplane
mode. In airplane mode, the RF function will be disabled.
The RF function can also be enabled or disabled through software AT commands. The following table
shows the RF function status of the module.
RM500Q-AE&RM502Q-AE_Hardware_Design
I/O Description
DI Airplane mode control. Active LOW.
OD Indicate RF status of the module.
OD Wake up the host.
DI Dynamic power reduction.
DI GNSS disable control.
DO Status indication to AP
DI Status indication from AP
RM500Q-AE&RM502Q-AE Hardware Design
5G Module Series
Comment
1.8/3.3 V
Open drain and
active low signal.
Open drain and
active low signal.
1.8 V power domain.
High voltage level by
default.
1.8/3.3 V power
domain.
Active LOW.
1.8 V power domain
1.8 V power domain
45 / 83