Table of Contents
Advertisement
NOTE
1)
This pin is pulled LOW by default, and will be internally pulled up to 1.8 V by software configuration only
when (U)SIM hot-plug is enabled by AT+QSIMDET.
4.1.2. (U)SIM Hot-plug
The module supports (U)SIM card hot-plug via the USIM1_DET pin. (U)SIM card insertion is detected by
high/low level. (U)SIM card hot-plug is disabled by default.
The following command enables (U)SIM card hot-plug function.
AT+QSIMDET (U)SIM Card Detection
Test Command
AT+QSIMDET=?
Read Command
AT+QSIMDET?
Write Command
AT+QSIMDET=<enable>,<insert_level>
Maximum Response Time
Characteristics
Parameter
<enable>
<insert_level>
RM510Q-GL_Hardware_Design
Integer type. Enable or disable (U)SIM card detection.
0
Disable
1
Enable
Integer type. The level of (U)SIM detection pin when a (U)SIM card is inserted.
0
Low level
1
High level
Response
+QSIMDET:
(list
of
supported <insert_level>s)
OK
Response
+QSIMDET: <enable>,<insert_level>
OK
Response
OK
Or
ERROR
300 ms
The command takes effect after the module is restarted.
The configuration will be saved automatically.
5G Module Series
RM510Q-GL Hardware Design
supported
<enable>s),(list
of
37 / 87
Advertisement
Table of Contents
