Operations For Nonlinear Editing (Operations In Cut Units) - Sony MAVE-F555 Operation Manual

3-2 Operations for Nonlinear Editing
(Operations in Cut Units)
3-2

Operations for Nonlinear Editing (Operations in Cut Units)

Definition of "Cut"
3-8 (E)
Chapter 3 Operations for Linear/Nonlinear Editing
Using the MAVE-F555 and a BVE-series editor to operate the MAV-555, you
can carry out nonlinear editing operations, such as adding or deleting a cut,
which were not possible with a conventional BVE-series editor alone.
NOTE
To carry out the nonlinear editing operations described in this section, it is
necessary to set the MAV-555 operation mode to BVE mode.
For more details, refer to the MAV-555 Operation Manual.
The term "cut" in this section refers to the unit in which you carry out editing,
and to the editing unit within the editing result file. For example, suppose that
using two files A and B you create the following editing result file.
File A
File B
Editing result file
Here the sections (A) and (B) cut from files A and B are termed "cuts." The
editing result file consists of the two "cuts" (A) and (B), and these parts of the
editing result file are also referred to as "cuts."
The start and end points of each cut within the editing result file are termed
"cut points."
(A) (B)