Sony MAVE-F555 Operation Manual page 126

3-2 Operations for Nonlinear Editing (Operations in Cut Units)
3-24 (E)
Chapter 3 Operations for Linear/Nonlinear Editing
Handling of exceptional cases
(1) If the player OUT point calculated automatically from the recorder IN and
OUT points is outside the outside the range of the file on the player, the
OUT point is positioned at the end of the file (last frame) on the player as
shown in the figure below.
Player
Recorder
Result of executing edit
However, even if you make modifications as above, the original OUT
point is still brought to the front by cut jump operation.
(2) If the recorder OUT point calculated automatically from the player IN and
OUT points and the recorder IN point is outside the outside the range of
the file on the recorder, the length of the file on the recorder as the editing
result is increased as shown in the figure below.
Player
Recorder
Result of executing edit
NOTE
As in conventional linear editing, the OUT point is not included in the editing
interval. Therefore, it is not possible to specify up to the last frame of the
recorder file to be overwritten. To overwrite up to and including the last frame
of the recorder file, leave the recorder OUT point unset, as above, and carry
out the overwriting with only the player OUT point set.
You can also use this function with a BLACK/MUTING loaded on the player
to delete up to and including the last frame of the recorder file.
IN
Amended OUT point
IN OUT
IN OUT
IN
Automatic calculation of
fourth edit point
t out of range
Automatic calculation of
fourth edit point
t allowed even if
out of range