Sony MAVE-F555 Operation Manual page 123

5
As for the IN point, using the jog dial of the BVE-series editor, for
example, search for the end position (OUT point) of the source of the
replacement cut.
6
Press the MARK OUT key on the MAVE-F555.
• The time data of the OUT point appears on the monitor screen.
7
Select the recorder port.
8
Using the jog dial of the BVE-series editor, for example, search for the
start position (IN point) of the section where you will make the
replacement.
9
Press the MARK IN key on the MAVE-F555.
• The time data of the IN point appears on the monitor screen.
10
Using the jog dial of the BVE-series editor, for example, search for the end
position (OUT point) of the section where you will make the replacement.
11
Press the MARK OUT key on the MAVE-F555.
• The time data of the OUT point appears on the monitor screen.
12
Using the channel specification keys (V, A1, A2, A3, and A4), select the
channel(s) where you will make the replacement.
• Press the key(s) corresponding to the channel(s) in which you want to
make the replacement, turning on the indicator(s) above the key(s).
• If you select only specific channels for the cut replacement, to make the
lengths of all channels the same, BLACK/MUTING material is added as
appropriate at the end of the short channels.
13
To execute the cut replacement, press the EXECUTE/REC key.
• This carries out the replacement, and "EDITED" appears on the monitor
screen.
• The recorder file is replaced by the editing result file (the file after
making the replacement), and the unit cues up to the OUT point of the
replaced section.
NOTE
• After executing the cut replacement, as the recorder file is replaced by the
editing result file, the monitor screen goes temporarily blank.
For details of the holding period for the player and recorder IN point and OUT point,
see Section 3-2-6, "IN Point and OUT Point Holding Periods" (page 3-33).
Chapter 3 Operations for Linear/Nonlinear Editing
3-21 (E)