Cli Mode Management - Planet Networking & Communication IGS-10020HPT User Manual

3.3 CLI Mode Management

There are two ways for CLI mode management, one is remote telnet and the other operated from console port. Remote telnet is
an IP-based protocol and console port is for user to operate the Industrial Managed PoE+ Switch locally only; however, their
operations are the same.
The command line user interface is for performing system administration, such as displaying statistics or changing option
settings. When this method is used, you can access the Industrial Managed PoE+ Switch remote telnet interface from
personal computer, or workstation in the same Ethernet environment as long as you know the current IP address of the
Industrial Managed PoE+ Switch.
Note:
1. The following console screen is based on the IGS-10020HPT; the display of the IGS-10020HPT is the
same as that of the IGS-10020PT/IGS-10020HPT/IGS-20160HPT.
Direct Access
Direct access to the administration console is achieved by directly connecting a terminal or a PC equipped with a
terminal-emulation program (such as HyperTerminal, ProcommPlus, putty, tera term) to the Managed Switch console (serial)
port. When using this management method, a straight DB9 RS-232 cable is required to connect the switch to the PC. After
making this connection, configure the terminal-emulation program to use the following parameters:
The default parameters are:

115200 bps baud rate

8 data bits

No parity

1 stop bit
User's Manual of IGS PoE series
49