Planet Networking & Communication IGS-10020HPT User Manual page 323

•
Sender IP Address
•
Sender IP Mask
• Target IP Filter
• Target IP Address
• Target IP Mask
• ARP Sender MAC
Match
• RARP Target MAC
Match
• IP/Ethernet Length
• IP
Network: Sender IP filter is set to Network. Specify the sender IP address
■
and sender IP mask in the SIP Address and SIP Mask fields that appear.
When "Host" or "Network" is selected for the sender IP filter, you can enter a
specific sender IP address in dotted decimal notation.
When "Network" is selected for the sender IP filter, you can enter a specific
sender IP mask in dotted decimal notation.
Specify the target IP filter for this specific ACE.
Any: No target IP filter is specified. (Target IP filter is "don't-care".)
■
Host: Target IP filter is set to Host. Specify the target IP address in the
■
Target IP Address field that appears.
Network: Target IP filter is set to Network. Specify the target IP address
■
and target IP mask in the Target IP Address and Target IP Mask fields that
appear.
When "Host" or "Network" is selected for the target IP filter, you can enter a
specific target IP address in dotted decimal notation.
When "Network" is selected for the target IP filter, you can enter a specific target
IP mask in dotted decimal notation.
Specify whether frames can hit the action according to their sender hardware
address field (SHA) settings.
0: ARP frames where SHA is not equal to the SMAC address.
■
1: ARP frames where SHA is equal to the SMAC address.
■
Any: Any value is allowed ("don't-care").
■
Specify whether frames can hit the action according to their target hardware
address field (THA) settings.
0: RARP frames where THA is not equal to the SMAC address.
■
1: RARP frames where THA is equal to the SMAC address.
■
Any: Any value is allowed ("don't-care").
■
Specify whether frames can hit the action according to their ARP/RARP
hardware address length (HLN) and protocol address length (PLN) settings.
0: ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the
■
(PLN) is equal to IPv4 (0x04).
1: ARP/RARP frames where the HLN is equal to Ethernet (0x06) and the
■
(PLN) is equal to IPv4 (0x04).
Any: Any value is allowed ("don't-care").
■
Specify whether frames can hit the action according to their ARP/RARP
hardware address space (HRD) settings.
0: ARP/RARP frames where the HLD is equal to Ethernet (1).
■
1: ARP/RARP frames where the HLD is equal to Ethernet (1).
■
Any: Any value is allowed ("don't-care").
■
323
User's Manual of IGS PoE series