Configuring Nat - HIKVISION NVST HNR Series User Manual

 Select Receivers: Select the receiver. Up to 3 receivers can be configured.
 Receiver: The receiver's name.
 Receiver's Address: The e-mail address of the user to be notified.
 Enable Attached Picture: Check to send e-mail with attached alarm images. The interval is the time
between sending two subsequent alarm images.
Click Apply.
(Optional) Click Test to send a test e-mail.

Configuring NAT

Purpose:
Two ways are provided for port mapping to realize the remote access via the cross-segment
network, UPnP™ and manual mapping.
TM
UPnP

Universal Plug and Play (UPnP™) can permit the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP™ function to enable the fast connection of the device
to the WAN via a router without port mapping.
Before you start:
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of
the router to which your device is connected. When the network working mode of the device is set
as multi-address, the Default Route of the device should be in the same network segment as that
of the LAN IP address of the router.
Go to Menu > Configuration > Network > NAT.
Network Video Recorder User Manual
188