Table of Contents
Advertisement
Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
Select the Full Screen Monitoring alarm linkage action.
Select the channel(s) in Trigger Channel settings you for make full screen monitoring in
Trigger Channel Settings.
Auto-switch will terminate once the alarm stops and back to the live view interface.
Configure Audio Warning
The audio warning has the system to trigger an audible beep when an alarm is detected.
Go to System>View>General.
Enable the audio output and set the volume.
Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
Select the Audio Warning alarm linkage action.
Notify Surveillance Center
The device can send an exception or alarm signal to the remote alarm host when an event occurs.
The alarm host refers to the PC installed with client software (e.g., CMS, Guarding Vision).
Go to System > Network > Advanced > More Settings.
Set the alarm host IP and alarm host port.
Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
Select the Notify Surveillance Center.
Configure E-mail Linkage
The system can send an email with alarm information to a user or users when an alarm is
detected.
Please refer to Chapter 16.8 Configure Email for details of Email configuration.
Go to System>Network>Advanced.
Configure the e-mail settings.
Go to the Linkage Action interface of the alarm detection (e.g., motion detection, video
tampering, face detection, etc.).
Select the Send Email alarm linkage action.
Network Video Recorder User Manual
149
Advertisement
Table of Contents
